AP-Asian Pride GraphiX by AsiaNinNinG

2g Go Faster Recipe
Stage 1
Introduction

Introduction Stage 1 Stage 2 Intermission Stage 3 Stage 4 Stage 5

    The point of this stage is to make the car a bit faster at as small a price as possible and has the best chance of passing dealer inspection especially since most of them are easily reversible.

The boost gauge is NOT optional

  1. Mechanical Boost Gauge ($65 + $25 for pod)
  2. BOV Return / Dump Tube free or $5 to be reversible)
  3. Blow Off Valve / Compressor By-Pass Valve ($85)
  4. Boost Control Solenoid Restriction Removal (free, pointless until you get a new BOV)
  5. Upper IC Pipe ($75)
  6. Cone Type Air Filter ($85)
    Note: Although #4 is a nice cheap mod which will raise boost. However, if oyu plan on getting an aftermarket exhaust I highly recommend you go ahead and get your hands on a quality manual boost controller. Because removing the restrictor and using a aftermarket exhuast will give you some bad problems with boost spike. The manual boost controller (MBC) from either Buschur Racing (Hallman), Doug's Dynopower, Extreme Motorsports, or Mark Hessler all work basically the same and make for EXCELLENT controllers. Don't confuse these with simple variable orifice valves. These are all spring and ball type valves, which allow for maximum spool and minum spike. I have the Buschur valve and it has much less boost spike than removing the restrictor or a simple fish valve. But for the time being if you want to wait to spend the money on a quality MBC that is fine. Just take into consideration you future mods.

1/4 mile 14.4-14.5
Cost $330





[ Webmaster - AsiaNinNinG ]